Success! – Glass Flash 1.0

July 20, 2021

Tuesday July 20, 2021 – If at first you don’t succeed, try again, and again, and again, and again…

This little light may seem insignificant, but taking a concept from your mind and designing it in a virtual 3d environment and printing it out to have and to hold is a very rewarding process! It’s equally fun and addicting as it is frustrating, but even the setbacks are fun because you’re always learning! As you can see from the photos below, it took some tweaking and retweaking but I finally have some working flashlights for my glasses! And now that they’re designed I can print them out again and again for as long as I need. The piece that slides onto the glasses arm is also editable should any of you want to try a set. They can be turned on individually or you can have both on at once. The added weight isn’t noticeable.

No comments

Leave a Reply

Your email address will not be published. Required fields are marked *